Sustainability in Project Management

Sustainability in Project Management This review discusses the journal Sustainable Project Life Cycle Management: the need to integrate life cycles in the manufacturing sector (2005) authored by Labuschagne and Brent. The theme of this paper is that incorporating the current project management methodologies with the principles of sustainable development requires comprehensive understanding and integration of different life cycles.[1] This journal provides a good introduction of life cycle management; however, the authors do not make holistic perspective on the aspects of sustainability in project management. At the outset of the paper, the authors note that the social, economic, and environmental impacts of a project long after its completion have required increasing attention; the project life cycle management principles thus require revision. However, reasons for the consideration to life cycles when aligning sustainability with project management has not been specified. According to Azapagic (2004), people may unintentionally aggravate the impacts when trying to alleviate them. Therefore, protecting the environment without increasing burdens can only be assured by adopting a systems approach based on life cycle thinking which takes the whole life cycle of an activity into account.[2][3] Labuschagne and Brent (2005) have focused on defining various life cycles, yet the descriptions of the proposed impact assessment indicators on the three main sustainability dimensions are only briefly stated which causes the concept rather vague. In 2005, Brent and Visser demonstrated an environmental performance resource impact indicator (EPRII) calculation procedure by introducing the life cycle impact assessment (LCIA) framework for comparing burdens at operational level.[4] The approach evaluated impacts in four different resource groups including water, air, land, and mined abiotic resources[5] based on three process parameters comprising water and energy usage, and waste produced.[4] Research regarding the social sustainability dimension has also been executed subsequently. All the social criteria and its sub-criteria were verified with respect to project management and business[6][7], but particular impacts were found to be more significant in certain appraised asset or techn ology life cycle phases. The EPRII approach was used as a basis to calculate the social impact indicators; however, results appeared to be unreliable and the method was hence concluded to be not applicable for decision-making purposes at the moment due to the lack of social project and footprint information (Labuschagne and Brent, 2008; Labuschagne and Brent, 2006).[7][8] Despite its defect, this paper is a well structured piece of work which utilizes a large number of diagrams and tables. Koedinger (1992) explained that diagrammatic representation outperforms sentential expression due to its use of location to group information which facilitates search and avoids the need of symbolic labels and also encourages perceptual inferences.[9] This consequently enables readers to have a better understanding of the concept. In conclusion, although this journal does not provide a holistic overview of sustainability in project management, its detailed descriptions of various life cycles and their interactions in projects have provided an explicit concept of project life cycle management. Moreover, a considerable amount of literature review has been carried out in this article; it therefore deserves to be widely read. References Labuschagne, C. and Brent, A.C. (2005), Sustainable Project Life Cycle Management: the need to integrate life cycles in the manufacturing sector, International Journal of Project Management, vol. 23, no. 2, pp. 159-168, Azapagic, A. (2004), Appendix: Life Cycle Thinking and Life Cycle Assessment (LCA), in Azapagic, A., Perdan, S., and Clift, R. (ed.), Sustainable development in practice: case studies for engineers and scientists, John Wiley and Sons, pp. 426-437. Azapagic, A., Millington, A., and Collett, A. (2006), A Methodology for Integrating Sustainability Considerations into Process Design, Chemical Engineering Research and Design,vol. 84, no. 6,pp. 439-452. Brent, A.C. and Visser, J.K. (2005), An environmental performance resource impact indicator for life cycle management in the manufacturing industry, Journal of Cleaner Production, vol. 13, no. 6, pp. 557-565. Brent, A.C. (2004), A life cycle impact assessment procedure with resource groups as areas of protection, The International Journal of Life Cycle Assessment, vol. 9, no. 3,pp. 172-179. Labuschagne, C., Brent, A.C., and van Erck, R.P.G. (2005), Assessing the sustainability performances of industries, Journal of Cleaner Production, vol. 13, no. 4, pp. 373-385. Labuschagne, C. and Brent, A.C. (2008), An industry perspective of the completeness and relevance of a social assessment framework for project and technology management in the manufacturing sector, Journal of Cleaner Production, vol. 16, no. 3, pp. 253-262. Labuschagne, C. and Brent, A.C. (2006), Social Indicators for Sustainable Project and Technology Life Cycle Management in the Process Industry, The International Journal of Life Cycle Assessment, vol. 11, no. 1, pp. 3-15. Koedinger, K.R. (1992), Emergent Properties and Structural Constraints: Advantages Diagrammatic Representations for Reasoning and Learning, SS-92-02, AAAI Technical Report, viewed 21 March 2010,

Land And Water Pollution Essay

Major types of water pollution Organic wastes that is largely untreated human waste, sewage, and industrial waste from processing various food roducts, from the pulp and paper industry, and from animal feedlots. Inorganic pollutans that is salt brines, acids, phospates, heavy metals, asbestos, PCBs, radioactive chemicals. Land Pollution Toxic substances Hazardous or toxic substances are those that can cause an increase in mortality rates or irreversible or incapacitating illness or those that have other seriously adverse health or environmental effects. Toxic substances that have been released on land include acidic chemicals, inorganic metals (such as mercury or arsenic) flammable solvents, pesticides, herbicides, phenols, explosives, and so on. For example benzene is a common industrial chemical that is also used in plastics, as well as dyes, nylon, food additives, detergents, drugs, fungicides, and gasoline. Benzene is a toxic and can cause of a anemia, bone marrow damage, and leukimia. Studies have shown that benzene workers are several times more likely than the general population to get leukimia. Solid wastes come from residential garbage, industrial wastes, agricultural wastes, mining wastes. The most common one we usually meet is residential garbage. Only about a third residential wastes are recovered through recycling. A low proportion that is due to the lack of financial backing for recycling operations, the small size of markets for recycled products, and toxic chemicals present in recyclable garbage. City garbage dumps are significant sources of pollution, containing toxic substances such as cadmium (from rechargeable battery), mercury, lead (from car battery, and TV pictures tube), vanadium, copper, zinc, and PCBs. Nuclear wastes Light water nuclear reactors contain radioactive materials, includeing known carcinogens such as strontiums 90, cesium 137, barium 140, and iodine 131. Extremely high levels of radiaton from these elements can kill a person, lower dosages (especially if radioactives dust particles are inhaled or ingested) can cause thyroid, lung, or bone cancer as well as genetic damage that will be transmitted to future generations. Depletion of Species and Habitats Human activity has rendered dozens of plants and animal species extinct. Since 1600 at least 96 known pecies of mammals and 88 major identifiable species of birds are known to have become extinct. Several hundred more species such as whales and salmon today find themselves threatened by commercial fishing. Forest habitats on which the bulk of species depend are also being decimated by the timber industry. Depletion of Fossil Fuels Until the early 1980s, fossil fuels were being depleted at an exponentially rising rate. That is, the rate at which they were being used had doubled with the passage of a regular fixed time period. Some early predictions of resources depletion assumed that fossil fuels would contiinue to be depleted at these exponentially rising rates. If continued, an exponentially rising rate of depletion would end with the complete and catastrophic depletion of the resource in a relatively short time. Estimated world resources of coal would be depleted in about 100years, estimated world reserves of oil would be exhausted in about 40years and estimated reserves of natural gas would last only about 25years. Depletion of Minerals If earlier exponentially rsing rates of depletion continued then alumunium would have been scheduled for exhaustion in the year 2003, iron in 2025, manganese in 2018, molybdenum in 2006, nickel in 2025, tungsten in 2000, zine in 1990, and copper and lead in 1993. World resources are also limited, and the depletion rates of the world’s supplies of minerals will also eventually peak and then gradually decline as remaining supplies become harder and more expensive to mine. The precise impact the limitation of worlds supplies will have on us exceedingly difficult to predict. Miningtechnologies may continue to develop , which will reduce the difficulty and cost of mineral extraction and extend the period of decline. This has in fact been the case for most mineras up to the present. Increased recycling may reduce the need for intensive mining of remaining minerals reserves. Substitutes may be found for many of the minerals whose supply is limited, and technological development may make many current uses of these  minerals obsolete.

The Definitions Of Malpractice And Malpractice - 1029 Words

In unit 9 the main components that will be utilized are the definitions of malpractice, how to prepare for court as a defendant, as well as what pieces of a trial consist of. Also there will be a component discussing compensatory negligence. Liability issues Parties involved and who should be sued Defenses of the parties Documents used by the Plaintiff’s side will ask for and how they will be used Standards of care Duty, breach, damages, and proximate cause Insurance issues Risk management issues before and after the incident Documentation and mandatory reporting Who should write the incident report and what should it say? The doctrine of Respondeat Superior and how it would apply The issues surrounding informed consent Preparation for court of the parties Proving malpractice occurred can be difficult. For instance in case study one, there are several things that might constitute malpractice but there are also such issues as informed consent and the acknowledgement that not all adverse events are caused by malpractice. Despite what may be a common societal belief, not all unexpected, unintended, or even undesired medical results can be attributed to the fault of a healthcare provider. The law identifies that much of nursing care requires clinical judgment. Therefore, a patient must prove four requisite elements to establish a malpractice case. First, the patient must establish that there was a nurse-patient relationship (Giordano, 2003). It is out of the nurse-patientShow MoreRelatedTort Reform And Medical Malpractice1083 Words   |  5 Pagescap placed on medical malpractice cases and other cases that are of negligence would standardize the monetary compensation regardless of the damage. In my opinion, Medical malpractice tort reform is a gray area, for each breach of the standard of care involves a different story and person, therefore the damages vary and should be evaluated fairly. In this essay, both sides of the argument are discussed, with a focus on medical malpractice tort reform. Proof of Malpractice For a plaintiff to triumphRead MoreMedical Malpractice Conditions in Ohio1502 Words   |  6 Pagesï » ¿Medical Malpractice Statutes and Procedures in Ohio and Michigan Today Introduction Across the country, there are calls for medical malpractice tort reform based on the perception of frivolous lawsuits by patients with patients without valid claims and less-than-scrupulous lawyers are willing to prosecute them. On the one hand, the fact that some plaintiffs have received enormous settlements as a result of their medical malpractice lawsuits further fuels the debate that tort reform is neededRead MoreCommon Accounting Malpractices in the Philippines700 Words   |  3 PagesCommon Accounting Malpractices in the Philippines Going back to the definition of accounting, it states that it is a system where in it records financial transactions pertaining to a business. Accounting also measures the ability of a business, it process information’s to be reported to the management whos making decisions. Accounting is very complicated especially when it comes doing the financial statements. Yes, professionals have enough knowledge regarding accounting but there are times thatRead MoreAmputation Mishap1398 Words   |  6 Pages The newspaper article states the mishap is negligence. In the following paragraphs, negligence, gross negligence, and malpractice are discussed and determine if the newspaper’s statement of negligence is correct. Ethical principles in nursing and nursing documentation regarding such issues are also discussed. Negligence and malpractice fall under the tort laws definition. According to Guido (2010), â€Å"Torts are civil wrongs, not based on contracts, but on personal transgressions in that the responsibleRead MoreNursing Malpractice And Negligence And Its Effects On Patients Essay1094 Words   |  5 PagesFarhan Mohammadi Ms. Tidwell English 1A 01 December 2016 Nursing Malpractice and Negligence and its Effects on Patients There are many different variations of healthcare professionals that assist people in regaining and maintaining a healthy lifestyle. The career field of licensed nursing is often considered to be one of the most vital professions within the medical community. Registered nurses work to prevent and heal various different types of injuries, diseases, and illnesses. They are alsoRead MoreEssay on Negligence in Nursing: The Legal Aspects952 Words   |  4 Pagesâ€Å"The definition of a health professional is a person who works to protect and improve people’s health by the diagnosis and treatment of illness to bring about a complete recovery from mental, physical and social perspectives, either directly or indirectly (Kurban, 2010, pg. 760).† Nurses in the community today have acquired an increasing responsibility to intervene with medical decisions. In the past, there were clear differences between nurses and doctors. It was more common for a nurse to be supervisedRead Mo reMedical Malpractice And Its Effects1714 Words   |  7 PagesMedical Malpractice and Its Effects According to the American Bar Association â€Å"Medical malpractice is defined as negligence committed by a professional health care provider—a doctor, nurse, dentist, technician, hospital or hospital worker—whose performance of duties departs from a standard of practice of those with similar training and experience, resulting in harm to a patient or patient s†. Medical malpractice makes it hard for physicians to do their job without having the fears of gettingRead MoreReform Malpractice Laws to Create True Healthcare Reform Introduction1610 Words   |  7 Pagesdiagnosed with†¦Ã¢â‚¬  These words are spoken in hospitals around the country every day and each time they are spoken, a line is drawn between doctor and patient. On one side is the doctor wondering if enough has been done to defend against being sued for malpractice. On the other side is the patient with a need for someone to blame for his or her condition and seeing the doctor as the s ole reason for any injured state. This division between doctor and patient has led to a practice called defensive medicineRead MoreImproving Quality Care Internally And Internally1215 Words   |  5 Pagesthe clinical practice of medicine. The Act does little to address medical malpractice head on, however there are indirect impacts that will increase a provider’s exposure to medical malpractice liability (Chirba Noble, 2013). In response to the ACA, the American Medical Association has drafted model legislation to shield providers from newly created malpractice claims resulting from the ACA. It would prevent malpractice claimants from using federal or state practice guidelines, quality measuresRead MoreExamination Malpractice9287 Words   |  38 PagesCHAPTER ONE INTRODUCTION 1.0 BACKGROUND TO THE STUDY The quest for exploration into â€Å"the effect of examination malpractice among the sociology student of University of Abuja† is borne out of the concern for the need for improvement/provision of enabling a good conducive environment that is conducive for the writing of examination and to avoid malpractice. In any given society, there are rule guiding the behavior of individuals as well as rights which give the people the freedom to express them. So